Journal of Jianghan University(Natural Science Edition) ›› 2011, Vol. 39 ›› Issue (2): 43-46.
Previous Articles Next Articles
FU Le-rong,WEN Shun,YUAN Chuang
Received:
Online:
Published:
Abstract: Stamping process of an automobile cover part was analysed based on finite element simulating analysis aided by Autoform software, to make sure the reasonable parameters,the stamping process scheme,and designed the complete dies.Several sets of compound stamping dies, which employed cam driver and cam slide for stretch drawing, hole punching, trimming, flanging, sizing, etc., were completed. The quality of final products produced by these dies showed that the stamping process was feasible and the dies were reliable.
Key words: automobile panel, mould, Autoform
CLC Number:
TG386.3
FU Le-rong,WEN Shun,YUAN Chuang. Stamping Die Design for Automobile Panel Based on Autoform[J]. Journal of Jianghan University(Natural Science Edition), 2011, 39(2): 43-46.
0 / / Recommend
Add to citation manager EndNote|Reference Manager|ProCite|BibTeX|RefWorks
URL: https://qks.jhun.edu.cn/jhdx_zk/EN/
https://qks.jhun.edu.cn/jhdx_zk/EN/Y2011/V39/I2/43